ELGILOY SPECIALTY METALS

Strip – Nickel 200/201 Alloys

Strip – Nickel 200/201 Alloys

Nickel 200/201 Alloys

UNS N02200 & N02201
W.Nr 2.4060/2.4066 & 2.4061/2.4068

Applications

Burst disks, evaporators, combustion boats, electronic components, chemical drums, reactors, vessels, missile components

Description

Nickel 200 is a solid solution strengthened, commercially pure material with good mechanical properties over a wide range of temperatures. It has excellent resistance to many corrosives, particularly hydroxides. Nickel 200 has high electrical and thermal conductivity and is ferromagnetic. It offers very good weldability and formability.

Industries Supplied

Chemical processing and manufacturing, Electronics, Aerospace & Defense

Nominal Composition

C: 0.15/0.02 max
Mn: 0.35 max
Si: 0.35 max
S: 0.01 max
Cu: 0.25 max
Ni: Balance
Fe: 0.40 max

Physical Properties

Density: 0.321 lb/in3, (8.9 g/cm3)

Modulus of Elasticity (E):
At 70°F (20°C): 29.7 x 103 ksi (205 GPa)

Modulus of Rigidity (G)
At 70°F (20°C):  11.55 x 103 ksi (79.6 GPa)

Coefficient of Expansion:
18.44 microinches/in.-oF (70-932oF)
15.2 µm/m-°C (20-500°C)

Electrical Resistivity: 3.15 µohm-in, (8.5 µohm-cm)

Thermal Conductivity:
487 Btu-in/ft2hr-°F
70.2 W/m-K

Applicable Specifications

Strip and Foil: AMS 5553, ASTM B162, DIN 17740, DIN 17750

Typical Mechanical Properties

  • Annealed
    • Heat Treatment: 1300-1700°F (705-925°C)
    • Tensile Strength: 55-75 ksi (380-520 MPa)
    • Suggested Operating Conditions: -300°F to 1000°F (-184°C to 540°C)
  • Spring Temper
    • Heat Treatment: Stress relieve as needed)
    • Tensile Strength: 90 ksi min
    • Suggested Operating Conditions: -300°F to 1000°F (-184°C to 540°C)

For further information Contact:

Contact Us
Phone: 1 888 843 2350
Elgiloy Specialty Metals – Strip Products
1565 Fleetwood Dr.
Elgin, IL 60123 USA

Limitation of Liability and Disclaimer of Warranty:

  • The content in these data sheets is provided primarily by third-party melting mills and is provided for reference only.  It is not intended for engineering or design.
  • Applications may be discussed, however, Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, does not recommend or endorse any material for any particular end use or application.
  • The data included in this data sheet are typical values and may vary.
  • Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, makes no representations or warranties, express or implied, as to the accuracy, completeness, condition, suitability, performance, fitness for a particular purpose, or merchantability of any information contained in any data sheet.

In no event will Elgiloy Specialty Metals, a Division of Combined Metals Company LLC, be liable for any damages whatsoever arising from the use of the information included in the data sheets.